Cisco MGX MGX 8800 Hardware Installation Manual page 465

Chapter 5 Installing the Cisco MGX Switch or Gateway
Figure 5-48
Alignment key
The shrouds on the AC cables and the receptacles on the card cage and power trays are keyed to ensure
proper connections. Do not attempt to insert cables into shrouds that are not keyed for them.
The AC power interconnect cables from each tray must be connected to the backplane. If the cables are
Note
not connected, the power supply monitoring circuit will mistake this as voltage failure and will result in
a tripped circuit breaker.
You will need the following cables:
Cisco Systems part number 72-2420-XX
•
• Cisco Systems part number 72-2421-XX
Cisco Systems part number 72-2422-XX
•
Cisco Systems part number 72-2423-XX
•
See Table 5-4
cage and power trays:
Table 5-4
Cable Label
Card Cage A1
Card Cage B1
Card Cage B2
Card Cage A2
Cisco highly recommends that you install and use a redundant AC power supply.
Note
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Interconnect Cable for AC
To power
supply
(PS tray 1 J1)
and Figure 5-49 for assistance with connecting the AC power tray connectors to the card
AC Power Cable Connections
Card Cage Connect
PSA 1
PSB 1
PSB 2
PSA 2
Cable Label Power Tray Connector
PS Tray 1 J1 J1 on primary (top) PS Tray
PS Tray 2 J1 J1 on secondary (bottom) PS Tray
PS Tray 2 J2 J2 on secondary PS Tray
PS Tray 1 J2 J2 on primary PS Tray
Cisco MGX 8800/8900 Series Hardware Installation Guide
Installing the MGX 8950 Switch
Alignment key
To card cage
(card cage A1)
5-81