Cisco MGX MGX 8800 Hardware Installation Manual page 193

Chapter 2 Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
Table 2-26 RPM-PR Cards, Interfaces, and Supported Back Cards (continued)
Switch
RPM-PR Interface
RPM-PR-512 NNI/UNI
(512 MB DRAM)
For information on RPM-PR software features and configurations, refer to the Cisco MGX Route
Note
Processor Module (RPM-PR) Installation and Configuration Guide, Release 5.2. For technical
specifications for the RPM-PR cards, see the
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Supported
Back Card Ethernet Interfaces
MMF-FE Fast Ethernet, 100BASE-FX; choice of SC or MII
connector. MII connector requires external transceiver.
RJ45-4E/B Ethernet 10BASE-T.
RJ45-FE Fast Ethernet, 100BASE-FX; choice of RJ-45 or MII
connector. MII connector requires external transceiver.
MGX-RPM-1 Fast Ethernet, 100 BASE-TX, with coprocessor and RJ-45
FE-CP connector.
MGX-RJ45-5- Ethernet/Fast Ethernet/Gigabit Ethernet, 10 BASE-T,
ETH 100 BASE-TX, and 1000 BASE-T with RJ45 connector.
"RPM-PR Specifications" section on page
Cisco MGX 8800/8900 Series Hardware Installation Guide
Front Cards
Number of
Ethernet
Interfaces
1
4
1
1
5
A-7.
2-63