Cisco MGX MGX 8800 Hardware Installation Manual page 195

Chapter 2 Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
Table 2-27
Table 2-27
LED
CPU OK
CB TX
CB RX
LM1 OK
LM2 OK
Module Configurations
The RPM-PR supports the following module configurations:
•
•
For module configuration information, refer to
Note
Redundancy, and Bulk
RPM-XF
Supported models: MGX 8850 (PXM45), MGX 8850/B (PXM45), MGX 8950, MGX 8880
The RPM-XF cards are double-height service modules that support communication between non-ATM
services (such as Frame Relay and IP) and the ATM services on an ATM network.
The RPM-XF:
•
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
describes the LEDs on the RPM-PR.
RPM-PR LEDs
Status
Green
Yellow
Red
Off
Green
Off
Green
Off
Green
Red
Off
Green
Red
Off
Standalone.
1:N card set redundancy—No SRM is required.
Distribution".
Provides integrated IP in an ATM platform, making possible such services as integrated PPP and IP
virtual private networks (VPNs) that use MPLS technology.
Description
The RPM-PR card set (front card and back cards) is in the
active state.
The RPM-PR is in Standby mode.
The RPM-PR has failed.
The CPU is not operational.
Cells are being transmitted to the cell bus.
Cells are not being transmitted to the cell bus.
Cells are being received from the cell bus.
Cells are not being received from the cell bus.
There is a back card in the upper rear bay and the cable is
connected.
There is a back card in the upper rear bay but the cable is
not connected.
There is no back card in the upper rear bay.
There is a back card in the lower rear bay and the cable is
connected.
There is a back card in the lower rear bay but the cable is
not connected.
There is no back card in the lower rear bay.
Chapter 4, "Planning for Card Redundancy, Line
Cisco MGX 8800/8900 Series Hardware Installation Guide
Front Cards
2-65