Cisco MGX MGX 8800 Hardware Installation Manual page 47

Table 5 User Guides and Release Notes for Cisco Multiservice Switch Products (continued)
Document Title
Cisco MGX 8250 Edge Concentrator Overview, Release 1.1.3
DOC-7811576=
Cisco MGX 8250 Multiservice Gateway Command Reference,
Release 1.1.3
DOC-7811212=
Cisco MGX 8250 Multiservice Gateway Error Messages,
Release 1.1.3
DOC-7811216=
Cisco MGX 8800 Series Switch Command Reference, Release
1.1.3
DOC-7811210=
Cisco MGX 8800 Series Switch System Error Messages,
Release 1.1.3
DOC-7811240=
Cisco MGX 8800/8900 Hardware Installation Guide,
Releases 2 - 5.3
OL-4545-01
Cisco MGX 8800/8900 Series Configuration Guide, Release
5.2
OL-6482-01
Cisco MGX 8800/8900 Series Command Reference, Release
5.2
OL-6483-01
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Description
Describes the system components and function of the
Cisco MGX 8250 edge concentrator.
Provides detailed information on the general command line
interface commands.
Provides error message descriptions and recovery
procedures.
Provides detailed information on the general command line
for the Cisco MGX 8850 (PXM1), Cisco MGX 8250, and
Cisco MGX 8230 edge concentrators.
Provides error message descriptions and recovery procedures
for Cisco MGX 8850 (PXM1), Cisco MGX 8250, and
Cisco MGX 8230 edge concentrators.
Describes how to install the Cisco MGX 8950, the
Cisco MGX 8850 (PXM1E/PXM45), the Cisco MGX
8850/B (PXM1E/PXM45), and the Cisco MGX 8830
switches. Also describes how to install the MGX 8880 Media
Gateway. This document explains what each switch does and
covers site preparation, grounding, safety, card installation,
and cabling. The Cisco MGX 8850 switch uses either a
PXM45 or a PXM1E controller card and provides support for
both serial bus-based and cell bus-based service modules.
The Cisco MGX 8830 switch uses a PXM1E controller card
and supports cell bus-based service modules. The Cisco
MGX 8950 supports only serial bus-based service modules.
The Cisco MGX 8880 uses a PXM45/C controller card, and
supports only serial bus-based service modules. This
hardware installation guide replaces all previous hardware
guides for these switches.
Describes how to configure the Cisco MGX 8880 Media
Gateway. Also describes how to configure Cisco MGX 8850
(PXM1E), Cisco MGX 8850 (PXM45), the Cisco MGX
8850/B (PXM1E/PXM45), and Cisco MGX 8830 switches to
operate as ATM edge switches and the Cisco MGX 8950
switch to operate as a core switch. This guide also provides
some operation and maintenance procedures.
Describes the PXM commands that are available in the CLI
of the Cisco MGX 8850 (PXM45), Cisco MGX 8850
(PXM1E), Cisco MGX 8950, and Cisco MGX 8830 switches.
Also describes the PXM commands that are available in the
CLI of the Cisco MGX 8880 Media Gateway.
Cisco MGX 8800/8900 Series Hardware Installation Guide
Documentation
47