Table of Contents
Advertisement
Upgrade Precautions from 2.0.x
For 1+1 APS and while the standby card is resetting during the upgrade process, the far end APS status
is invalid and dspapsln will show the line is in mismatch or SF state (the NNI link will stay up). Once
the standby card comes up, alarm will be clear. This means that APS protection is lost during the standby
card reset.
The ILMI default value for Release 2.0.15 is 0 for UNI and NNI ports, but Release 3.0.10 uses the
minVPI defined in the partition.
Installation and Upgrade Procedures
The procedures to upgrade to Release 3.0.10 appear in "Appendix A, Downloading and Installing
Software Upgrades" in:
•
•
Note
For MGX-RPM-XF-512 upgrade information, refer to the Cisco MGX Route Processor Module
(RPM-XF) Installation and Configuration Guide, Release 3.
You can order manuals (see the
from the main Multiservice Switch Documentation site as follows:
Step 1
Go to http://www.cisco.com/univercd/cc/td/doc/product/wanbu/index.htm.
Step 2
Click on the link that matches your product name or configuration, for example:
•
•
•
Click on Release 3.
Step 3
Click on the Software Configuration Guide or RPM Installation manual.
Step 4
Caveats
This section provides information about caveats associated with Release 3.0.10 software.
MGX 8830 Caveats
Severity level 1, 2, and 3 caveats are organized in this section as follows:
•
•
OL-2914-01 Rev D0, July 3, 2003
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide, Release 3
(DOC-7814577=)
Cisco MGX 8850 (PXM1E) and MGX 8830 Software Configuration Guide, Release 3
(DOC-7814248=)
MGX 8850 (PXM45)
MGX 8850 (PXM1E)
MGX 8830
"MGX 8830 Open Caveats in Release 3.0.10"
"Status of MGX 8830 Caveats Found in Previous Releases"
Release Notes for Cisco MGX 8850 (PXM45), MGX 8850 (PXM1E), and MGX 8830, Software Release 3.0.10
"Obtaining Documentation" section on page
Caveats
115) or download them
55
Advertisement
Table of Contents
