Figure 5-46 Fan Power Cable - Cisco MGX MGX 8800 Hardware Installation Manual

Chapter 5 Installing the Cisco MGX Switch or Gateway
Figure 5-46
To card cage
Complete the following steps to connect the fan power cabling:
Insert the male connector of the upper fan tray power cable (46-inch) into the connector receptacle
Step 1
(labeled F1) located at the bottom of the card cage, and push the connector in to seat it.
Insert the connector at the other end of the cable into the upper fan tray receptacle as shown in
Step 2
Figure
Step 3 Tighten the captive screws on the connectors. Do not use a power tool.
Step 4 Insert the male connector of the lower fan tray power cable (12-inch) into the connector receptacle
(labeled F2) located at the bottom of the card cage, and push the connector in to secure it.
Insert the connector at the other end of the cable into the lower fan tray receptacle as shown in
Step 5
Figure
Tighten the captive screws on the connector. Do not use a power tool.
Step 6
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Fan Power Cable
5-47, and push the connector in to seat it.
5-47, and push the connector in to secure it.
Cisco MGX 8800/8900 Series Hardware Installation Guide
Installing the MGX 8950 Switch
To fan tray
5-79