Connecting The Back Card To The Mgx-8850-Aps-Con Connector - Cisco MGX MGX 8800 Hardware Installation Manual

Installing the MGX 8850 (PXM1E/PXM45) Switch, MGX 8850/B or MGX 8880 Media Gateway
Reinstall the APS Assembly
Complete the following steps to reinstall the APS assembly.
If you are not installing an APS assembly, go to the
Note
Place the edge of the back card in the alignment slot of the APS connector (see
Step 1
numbers). Use the guide tabs on the APS connector to align the holes on the back card with the pins on
the APS connector. (See
Figure 5-13
Guide tabs Guide tabs
Carefully install the back card in the APS connector by pushing firmly, with a straight motion, until the
Step 2
back card is securely connected
A rocking motion during connector mating can bend or damage the APS connector pins.
Caution
Repeat
Step 3
cards installed in the APS connector.
Cisco MGX 8800/8900 Series Hardware Installation Guide
5-26
Figure 5-13.)

Connecting the Back Card to the MGX-8850-APS-CON Connector

APS
connector
Top view
Step 1 and Step 2 to install a second back card in the APS connector.
Chapter 5 Installing the Cisco MGX Switch or Gateway
"Reinstall the Back Cards" section on page
Alignment
Back card slot
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
5-27.
Table 1-6 for part
Card extractors
shown in
"in" position
Figure 5-14 shows two back