Modem Connection To The Maintenance Port - Cisco MGX MGX 8800 Hardware Installation Manual

Chapter 5 Installing the Cisco MGX Switch or Gateway
Connect the MP Connection
This step is optional.
Note
A dial-up connection extends switch management to all workstations that have access to the public
switched telephone network (PSTN).
PXM-UI-S3
Connect the maintenance port (MP) on the PXM-UI-S3 card to a modem. Connect the terminal to a
power source and set it up using the values that are shown in
the PSTN and is accessible from a workstation, as shown in
PXM-UI-S3/B
A PXM-UI-S3/B card does not have a maintenance port. For the PXM-UI-S3/B card, a modem can be
connected to the console port instead of the MP.
Figure 5-30
PXM-UI-S3
back card
C
P
M
P
L
A
N
1
L
A
N
2
E
X
T
C
L
K
1
E
X
T
C
L
K
2
R
M
For further information about server management and configuration setup, refer to the appropriate
software configuration guide for your switch and your release.
Connect the LAN1/2 Ports
This step is optional.
Note
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006

Modem Connection to the Maintenance Port

Modem
PXM
UI-S3
Modem
A
L
A
Workstation
Installing the MGX 8850 (PXM1E/PXM45) Switch, MGX 8850/B or MGX 8880 Media Gateway
Cisco MGX 8800/8900 Series Hardware Installation Guide
Table 5-2. This modem is connected through
Figure 5-30.
5-47