Installation Procedures - Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual

Installation Procedures

See the following sections for the configuration tasks required to run the RPR/RPR+, SSO with NSF,
FSU, and SLCR features.
•
•
•
•
•
•
•
•
•
Enabling the Router
At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for a
Step 1
privileged-level password as follows:
Router> enable
Password:
Step 2 Enter the password (the password is case sensitive). For security purposes, the password is not displayed.
When you enter the correct password, the system displays the privileged-level system prompt (#):
Router#
The completes the enabling the router procedure.
OL-4923-01 B0
Enabling the Router, page 41
Copying an Image onto an RSP, page 42
Setting the Config-Register Boot Variable, page 43
Configuring RPR and RPR+, page 43
Configuring SLCR, page 59
Configuring NonStop Forwarding (NSF), page 49
Performing a Fast Software Upgrade, page 56
RPR, RPR+, SSO, and FSU Troubleshooting Tips, page 58
Configuring SLCR, page 59
(required)
(required)
(optional)
(optional)
(optional)
(optional; but SSO required)
(optional)
(optional)
(optional)
41