Figure 1-36 Mgx-8830-Aps-Con; Figure 1-37 Aps Assembly Example (Mgx-8830-Aps-Con); Table 1-8 Aps Connector Support For Mgx 8830 Or Mgx 8830/B Switch Modules - Cisco MGX MGX 8800 Hardware Installation Manual

Chapter 1 Product Overviews
Figure 1-37
in an APS connector forms an APS assembly. The APS assembly is installed in the rear of the switch.
For more information, see the
Figure 1-37
Table 1-8
and requirements, see
Table 1-8
Module
AXSM-2-622-E
AXSM-8-622-XG
AXSM-16-155- XG
MPSM-T3E3-155
PXM1E-4-155
PXM1E-8-155
SRME
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
shows an example of two back cards installed in an APS connector. Two back cards installed
Table 4-4
APS Assembly Example (MGX-8830-APS-CON)
lists the modules that the APS connectors support. For more information about APS options
Table 4-4.
APS Connector Support for MGX 8830 or MGX 8830/B Switch Modules
MGX-8830-APS-CON
(MGX 8830 and MGX 8830/B)
Yes
Yes
Yes
Yes
Recommended
Yes
Yes
Cisco MGX 8830 or MGX 8830/B Switch
Cisco MGX 8800/8900 Series Hardware Installation Guide
1-53