Table 2-13 Cesm Leds - Cisco MGX MGX 8800 Hardware Installation Manual

Front Cards
Table 2-13
Table 2-13
LED
ACT
STBY
FAIL
PORT 1 through
PORT 8
Module Configurations
The CESM supports the following module configurations:
•
•
•
•
For module configuration information, refer to
Note
Redundancy, and Bulk
Cisco MGX 8800/8900 Series Hardware Installation Guide
2-26
describes the LEDs on the CESM cards.
CESM LEDs
Status
Green
Yellow or
blinking yellow
Red
Green
Red
Yellow
Off
Standalone.
1:N card set redundancy, without bulk distribution.
1:N card set redundancy, with bulk distribution—For line redundancy to be supported in this
configuration, there must be redundant PXM1E or PXM45 cards and redundant SRME cards. The
APS connector must be installed between the SRME cards.
Bulk distribution.
Distribution".
Chapter 2 Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
Description
The CESM card set (front card and back card) is in active
state.
One of the following conditions exists:
The CESM is in Standby mode.
•
• The CESM is in mismatch state.
• The CESM DSPs are currently involved in the CESM
bootup process.
When this LED is solid red and the ACT and STBY LEDs
are off, one of the following conditions exists:
The module is in Reset mode.
•
The module has failed.
•
The card set is not complete (no back card).
•
The port is active with no alarms detected.
The port is active and a local alarm has been detected.
The port is active and a remote alarm has been detected.
The port is not configured, or the card set is configured as
a redundant card set and is in Standby mode.
Chapter 4, "Planning for Card Redundancy, Line
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006