Cisco MGX 8850 System Installation And Configuration Manual

Cisco systems plastic motherboard insulator installation and configuration guide

Hide thumbs Also See for MGX 8850 System:

Download this manual See also: Configuration Manual, Installation and Configuration Manual

Installing Plastic Motherboard Insulator in an

MGX 8850 System

Installing Backplane Plastic Insulating Cover

Use the following procedure to install the insulating cover over a system's backplane. This procedure

may be done without powering down the system.

Open the plastic grill on the front side of the intake plenum, located directly underneath the card cage

Step 1

or the fan space, using a flat blade screw driver to loosen the two recessed screws. Tilt the plastic grill

forward about 45 degrees, then lift out and set it aside.

Hold the plastic cover, shown in the drawing below, so that the 16 short tabs are facing towards you.

Step 2

Short tabs

Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706. USA

3 Tabs

78-10389-01

Page 1 Hold the plastic cover, shown in the drawing below, so that the 16 short tabs are facing towards you. Step 2 Short tabs Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706. USA Copyright © 2000. Cisco Systems, Inc. All rights reserved 3 Tabs...
Page 2 Slide the clear plastic backplane cover underneath the card cage and toward the bottom of the Step 4 backplane; the flange with the 3 tabs and 2 cutouts will face the backplane. Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01...
Page 3 A high-energy hazard exist in the system while it is running. Be careful not to let your fingers or thumb touch the motherboard. Do not wear loose clothing or jewelry, such as rings, bracelets, or chains while performing this installation. Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01...
Page 4 Step 8 Replace the plastic grill removed in Step 1 and secure with the two screws using a flat blade screw driver. This completes the installation of the plastic insulating cover. Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01...