Figure 5-45 Cable Management Assembly At Back Of System; Connect The Fan Tray Power Cables To The Mgx 8950 Switch - Cisco MGX MGX 8800 Hardware Installation Manual

Installing the MGX 8950 Switch
Install the Cable Management Assembly
The cable management assembly consists of two identical, horizontal cable managers, two mounting
brackets, and screws. Complete the following steps to install the cable management assembly:
Step 1 Use the provided No. 10-32 screws and the appropriate screwdriver to attach the two mounting brackets
to the right and left sides of the rear of the air intake and exhaust plenums.
Use the provided No. 10-32 screws and the appropriate screwdriver to install the cable managers on the
Step 2
mounting brackets. The cable guides on the upper cable manager must be on the bottom. The cable
guides on the lower cable manager must be on the top. See
Figure 5-45
Upper cable
management
assembly
Lower cable
management
assembly

Connect the Fan Tray Power Cables to the MGX 8950 Switch

The fan trays receive power from the backplane through a fan power cable. See
illustration of the fan power cable and
You will need the following cables for fan cable installation:
•
•
Cisco MGX 8800/8900 Series Hardware Installation Guide
5-78
Cable Management Assembly at Back of System
Cisco Systems part number 72-2083-xx (46-inch cable)
Cisco Systems part number 72-2565-xx (12-inch cable)
Chapter 5
Figure
Figure 5-47 for an illustration of the fan power connections.
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Installing the Cisco MGX Switch or Gateway
5-45.
Figure 5-46 for an