Switch Installation; Preparing For Installation; Warnings - Cisco Catalyst IE9300 Hardware Installation Manual

Switch Installation

•
•
•
•
•

Preparing for Installation

Before you install a Cisco Catalyst IE9300 Rugged Series Switch, you must read, understand, and observe
the warnings and guidelines in this section. You also must verify the switch package contents, gather the
required tools and equipment, and verify the switch operations.

Warnings

These warnings are translated into several languages in the Regulatory Compliance and Safety Information
for Cisco Catalyst IE9300 Rugged Series Switch. They apply to all the switch models.
Warning
Warning
Warning
Preparing for Installation, on page 13
Switch Installation, on page 16
SFP Installation, on page 29
Replace the SD Flash Memory Card, on page 35
Connecting Devices to the Ethernet Ports, on page 35
Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces,
and watches). Metal objects will heat up when connected to power and ground and can cause serious
burns or weld the metal object to the terminals. Statement 43
Read the installation instructions before you connect the system to its power source. Statement 1004
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
2
C H A P T E R
13