Nv200 Spectral Module Flash Codes; Tebs Lock Flash Codes; Spectral Payout Flash Codes - Innovative Technology Spectral NV200 User Manual

User Manual NV200 Spectral Range
<< Back to Contents
Firmware
1
Mismatch
Payout Jam
2
5
Payout Jam
4
recovery in
progress
Safe
5
Interface not
detected
Bunch Note
6 4
Feeder

8.2 NV200 Spectral Module Flash Codes

Each additional module for the NV200 Spectral has its own flash codes, outlined in the
subsections below.

8.2.1 TEBS Lock Flash Codes

The TEBS cashbox can display a flash code on the lock cam.
Flashes
Red Blue
3 2 Camera not Responding
3 3 EEPROM Error
3 4 TEBS Log CRC Error

8.2.2 Spectral Payout Flash Codes

The LED on top of the Spectral Payout module can flash the following codes to indicate
its status and aid troubleshooting
Flashes
Long
3
3
3
3
3
Flashes
Colour
Green
Green
Copyright © Innovative Technology Ltd 2019
The Firmware on the device connected doesn't match the firmware
on the NV200 Spectral. Ensure the Firmware supports the
connected device.
The spectral payout has encountered an issue and a note has
jammed, follow the steps as described in
The spectral payout encountered a jam and is attempting to
recover. 5 notes will be moved to the cashbox, from the payout.
Once the unit has completed this it will go back in service.
Check the connection to the Safe Interface module.
The Bunch Note feeder requires 24V DC.
Please check the Bunch Note Feeder connection.
Indicated Status / Error
Short
2
3
4
5
1
Flash
Slow Waiting for host machine to enable the payout
Fast
Section 9.4
Recommended Action
Arrange for the unit to be returned to the
nearest repair centre; details of which can be
found on our website.
Send the Clear TEBS Log command through
validator manager this will reset the logs and the
error should clear.
Indicated Status / Error
Sensor error
Tape error
Diverter Error
EEPROM Error
Other
Indicated Status
module
Idle
Doc: GA02119 User Manual NV200 Spectral Range
Version: 2.2
Page 74 of 113