Innovative Technology Spectral NV200 User Manual page 74

User Manual NV200 Spectral Range
<< Back to Contents
Currency
6
Mismatch
Firmware
7
Error
Incompatible
8
TEBS
Firmware
1
Checksum
Error
Interface
2
Checksum
Error
3
EEPROM
3
Checksum
Error
Dataset
4
Checksum
Error
Power Supply
1
too Low
Power Supply
2
too High
4
Card Format
3
Payout Reset
4
Copyright © Innovative Technology Ltd 2019
Remove the current TEBS bag and reinsert a new bag.
Contact ITL support.
The TEBS build revision is not supported by NV200 Spectral. Must
be build revision 9 or higher.
There has been an issue with the attempted download, retry the
download with the recovery section on validator manager, if this
fails arrange for the unit to be returned to the nearest repair
centre; details of which can be found on our website.
The firmware loaded doesn't contain the primary interface from the
previous firmware. Download with the IF file containing the correct
protocol.
There has been an issue with the attempted download, retry the
download with the recovery section on validator manager, if this
fails arrange for the unit to be returned to the nearest repair
centre; details of which can be found on our website.
Check the voltage on your power supply is within the specified
voltage range as outlined in
If the voltage appears to be correct, check to ensure the power
supply voltage doesn't vary by more than 10% under maximum
current draw.
Check the voltage on your power supply is within the specified
voltage range as outlined in
If the voltage appears to be correct, check to ensure the power
supply voltage doesn't vary by more than 10% under maximum
current draw.
The data card inserted is incorrect, format the card using the latest
NVCardUtilities.
The Spectral Payout is in the process of resetting, wait for it to
recover.
Section 3.4
Section 3.4
Doc: GA02119 User Manual NV200 Spectral Range
Version: 2.2
Page 73 of 113