Sd Card; General Description; Hardware Requirements - Innovative Technology Spectral NV200 User Manual

User Manual NV200 Spectral Range
<< Back to Contents
By selecting the Program tab, you can reprogram the NV200 Spectral. To begin the
upload, click open file, then browse to the file location (usually Downloads) before
clicking OK.
Once the file has been selected its information will be populated and the Program
device tab will become active. Finally, hit 'Program Device', the unit's bezel will now
begin to flash signaling the update has begun.
Interrupting the download process can result in
the unit entering a non-functional state, once the
process has started it cannot be halted.
When completed the unit will restart and a pop-up box will appear saying Device
Programming Complete.

5.4.2 SD Card

5.4.2.1 General Description

The NV200 Spectral can also be reprogrammed through the SD slot on the front of the
unit. To do this the SD card must be correctly formatted and meet the hardware
requirements defined in

5.4.2.2 Hardware Requirements

The SD card must meet the following hardware requirements:
The following SD card has been tested and recommended for best performance:
https://www.sandisk.co.uk/home/memory-cards/sd-cards/ultra-sd
Copyright © Innovative Technology Ltd 2019
Caution!
Section 5.4.2.2 below.
Minimum: 4GB – Class 4
Maximum: 32GB – Class 10
Doc: GA02119 User Manual NV200 Spectral Range
Version: 2.2
Page 48 of 113