Engine Disassembly; Preparations - Husqvarna FE 350 2015 Repair Manual

ENGINE
18
18.3 Engine disassembl
18.3.1

Preparations

-
Connect negative cable � of the battery.
Guideline
Screw, battery terminal
• Info
I
The contact disk
cable lug with the claws facing up.
-
Refill the coolant. (il,) p. 201)
-
Install the main silencer.
-
Install the right side cover.
-
Remove the motorcycle from the lift stand.
(FE 350S US)
-
Install the activated charcoal filter.
-
Install the fuel tank. (0
-
Mount the seat. (a p. 77)
(FE EU/ AU/US)
-
Install the fuel tank. (a
-
Mount the seat. (0 p. 77)
-
Remove screw cap � on the clutch cover and fill in engine oil.
I
Engine oil 11.20 I (1.27 qt.)
-
Mount and tighten fitting �-
Danger
Danger of poisoning
result in unconsciousness and death.
-
Always make sure there is sufficient ventilation when running the
engine.
-
Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
-
Start the engine and check that it is oil-tight.
-
Switch off the engine.
-
Check the engine oil level.
-
Check the coolant level.
-
Execute the initialization run.
Finishing work
-
Take a test ride.
-
Read out the fault memory using the Husqvarna Motorcycles diagnostics tool.
-
Check the engine for leak tightness.
-
Check the engine oil level.
-
Check the coolant level.
-
Install the engine guard.
-
Mount the special tool on the engine mounting block.
Engine fixing arm (77229002000)
Engine assembly stand (61229001000)
Mount the engine on the special tool.
Info
Work with an assistant or a motorized hoist.
M5
e
must be mounted between the battery terminal and
(il,) p. 71)
(il,) p. 77)
(a p. 11)
(0 p. 86)
p. 79)
p. 79)
I
Engine oil (SAE 1 0W/50)
Exhaust gases are toxic and inhaling them may
(� p. 202)
(� p. 200)
(� p. 211)
(0 p. 202)
(a p. 200)
(a p. 41)
(0 p. 293)
(� p. 292)
137
2.5 Nm
(1.84 lbf ft)
(0 p. 284)