Husqvarna FE 350 2015 Repair Manual page 119

16
BRAKE SYSTEM
>------400379-10
-
Open shut-off valve
• Info
I
Follow the operating instructions of the bleeding device.
-
Ensure that the filling pressure is set on pressure gauge t). Correct the filling
pressure on pressure regulator
Guideline
I
Filling pressure
-
Pull off protection cap
bleeder bottle hose.
I
Bleeding device (00029013100)
-
Open bleeder screw Q) by approx. one half turn.
• Info
I
Drain until fresh brake fluid emerges in the bleeder bottle hose without
bubbles.
-
Tighten the bleeder screw.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerging.
Info
•
I
Overfilling of the brake fluid reservoir is prevented.
-
Tighten the bleeder screw. Remove the bleeder bottle hose. Mount the pro­
tection cap.
-
Disconnect the bleeding device. Remove the bleeder cover.
-
Correct the brake fluid to level Q).
I
Guideline
Level Q)
I
Brake fluid DOT 4
-
Position the cover with the membrane. Mount and tighten the screws.
Info
•
I
Clean up overflowed or spilled brake fluid immediately with water.
-
Check the hand brake lever for a firm pressure point.
(FE 350S US)
-
Move the brake fluid reservoir mounted on the handlebar to a horizontal posi-
tion.
-
Cover painted parts.
-
Remove screws
-
Remove cover @ with the membrane.
-
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill
with fresh brake fluid.
G02092-10
Bleed syringe (50329050000)
Brake fluid DOT 4
-
Mount bleeder cover
I
Bleeder cover (00029013005)
-
Connect the bleeding device.
I
Bleeding device (00029013100)
G02093-10
8.
0
if necessary.
I
2 ... 2.5 bar (29 ... 36 psi)
0
of the brake caliper bleeder screw. Connect the
(!lll p. 288)
8.
I
5 mm (0.2 in)
(� p. 284)
O .
(a p. 289)
(� p. 284)
8.
(� p. 288)
(a p. 288)
117