Engine Disassembly; Preparations - Husqvarna FE 350 2014 Repair Manual

ENGINE
18
18.3 Engine disassembl�
18.3.1

Preparations

-
Connect negative cable � of the battery.
Guideline
Screw, battery terminal
• Info
I
O
Contact disk
cable lug with the claws facing up.
-
Refill the coolant. (,... p. 190)
-
Install the main silencer. (,... p. 71)
-
Install the right side cover. (,... p. 76)
-
Remove the motorcycle from the lift stand.(,... p. 11)
-
Install the fuel tank. (,... p. 78)
-
Mount the seat. (,... p. 76)
-
Remove screw cap � on the clutch cover and fill in engine oil.
I
Engine oil 11.20 I (1.27 qt.)
-
Mount and tighten fitting �-
Danger
Danger of poisoning
result in unconsciousness and/or death.
-
When running the engine, always make sure there is sufficient ventila­
tion, and do not start or run the engine in an enclosed space without
an effective exhaust extraction system.
-
Start the engine and check that it is sealed.
-
Switch off the engine.
-
Check the engine oil level. (,... p. 191)
-
Check the coolant level. (,... p. 189)
-
Execute the initialization run. (,... p. 200)
Finishing work
-
Take a test ride.
-
Read out the fault memory using the Husqvarna Motorcycles diagnostics tool.
-
Check the engine for leakage.
-
Check the engine oil level. (,... p. 191)
-
Check the coolant level. (,... p. 189)
-
Install the engine guard. (,... p. 41)
-
Mount the special tool on the engine mounting block.
Engine fixing arm (77229002000) (,... p. 263)
Engine assembly stand (61229001000) (,... p. 262)
Mount the engine on the special tool.
Info
Work with an assistant or a motorized hoist.
M5
must be mounted between the battery terminal and the
I
Engine oil (SAE 1 0W/50) (,... p. 256)
Exhaust gases are toxic and inhaling them may
128
2.5 Nm
(1.84 lbf ft)