Husqvarna FE 350 2015 Repair Manual page 36

6
FORK, TRIPLE CLAMP
8.
-
Tighten screw
Guideline
I
Screw, top steering head
-
Mount and tighten screw@.
Guideline
Screw, top steering stem
(FE EU/ AU/US)
-
Tighten screws @.
Guideline
Screw, top triple clamp
-
Secure the wiring harness with cable holder @).
(FE 350S US)
@).
-
Tighten screws
Guideline
Screw, top triple clamp
-
Secure the wiring harness with cable holder@).
-
Position the brake caliper. Mount and tighten screws Ci).
Guideline
Screw, front brake caliper
-
Mount the cable tie(s).
-
Position the brake line, wiring harness, and clamp. Mount and tighten screws
Finishing work
-
Install the front fender. (a
-
Install the front wheel. (a
-
Install the headlight mask with the headlight.
-
Check that the wiring harness, throttle cables, and brake and clutch lines can
move freely and are routed correctly.
-
Check the play of the steering head bearing.
-
Remove the motorcycle from the lift stand. (� p. 11)
-
Check the headlight setting.
I
M20x1.5
M8 17 Nm
(12.5 lbf ft)
M8
M8
M8 25 Nm
(18.4 lbf ft)
p. 87)
p. 94)
(!.:! p. 89)
(� p. 35)
(� p. 127)
34
112 Nm (8.9 lbf ft)
Loctite ® 243 ™
17 Nm
(12 .5 lbf ft)
17 Nm
(12 .5 lbf ft)
Loctite ® 243
™
G,.