Husqvarna FE 350 2015 Repair Manual page 206

21 LUBRICATION SYSTEM
8.
-
Remove screws Remove the oil filter cover with the 0-ring.
0
-
Pull oil filter out of the oil filter housing.
I
Circlip pliers reverse (51012011000)
-
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing area.
-
Lay the motorcycle on its side and fill the oil filter housing to about ½ full with
engine oil.
-
Fill the oil filter with engine oil and place it in the oil filter housing.
-
Lubricate the 0-ring of the oil filter cover and mount it with the oil filter cover (D.
-
Mount and tighten the screws.
Guideline
I
Screw, oil filter cover
-
Stand the motorcycle upright.
-
Remove the oil filler plug @ with the 0-ring from the clutch cover and fill up with
engine oil.
I
Engine oil 11.20 I (1.27 qt.)
• Info
I
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
m
-
Install and tighten the oil filler plug with 0-ring.
Danger
Danger of poisoning
result in unconsciousness and death.
-
Always make sure there is sufficient ventilation when running the
engine.
-
Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
-
Start the engine and check that it is oil-tight.
Finishing work
-
Check the engine oil level.
-
Install the engine guard.
(l!!l p. 289)
I
Engine oil (SAE 1 0W/50)
Exhaust gases are toxic and inhaling them may
(a p. 202)
(a p. 41)
204
10 Nm (7.4 lbf ft)
(l!!l p. 284)