Removing The Fork Protector - Husqvarna FE 350 2015 Repair Manual

6
FORK, TRIPLE CLAMP
6.9
Removing the fork rotector
(FE EU/ AU/US)
-
Tighten screws
Guideline
Screw, top triple clamp
Tighten screws (D.
Guideline
Screw, bottom triple clamp
(FE 350S US)
-
Tighten screws
Guideline
Screw, top triple clamp
Tighten screws (D.
Guideline
Screw, bottom triple clamp
-
Position brake caliper, and mount and tighten screws •.
Guideline
Screw, front brake caliper
-
Mount the cable binder.
-
Position the brake line, wiring harness, and clamp. Mount and tighten screws
Finishing work
-
Install the front wheel.
-
Install the headlight mask with the headlight.
-
Check the headlight setting.
Preparatory work
-
Switch off all power consumers and switch off the engine.
-
Remove the headlight mask with the headlight.
-
Raise the motorcycle with a lift stand.
-
Remove the front wheel.
-
Remove the fork legs.
Main work
-
Remove screws
-
Remove the screws on the right fork leg. Remove the fork protector upwards.
C00565-10
8.
MS
MS
8.
MS
MS
MS
(0 p. 94)
(0 p. 127)
(0 p. 11)
(0 p. 93)
(0 p. 15)
O
on the left fork leg. Remove the fork protector upwards.
17 Nm
(12 .5 lbf ft)
15 Nm
(11 .1 lbf ft)
17 Nm
(12 .5 lbf ft)
15 Nm
(11 .1 lbf ft)
25 Nm
Loctite ® 243
(18.4 lbf ft)
(0 p. 89)
(I!!:! p. 88)
16
™
0.