Disassembling The Piston Rod - Husqvarna FE 350 2015 Repair Manual

6
FORK, TRIPLE CLAMP

Disassembling the piston rod

Info
The steps are identical for both fork legs, except for the hydrostop needle and valve.
-
-
Remove lock ring
-
Pull reservoir @ off of the tube.
@)
-
Pull sleeve
-
Remove spring
201795-10
-
Remove seal rings 6!) and O-ring
-
Remove pilot bushings
Preparatory work
-
Disassemble the fork legs.
-
Remove the spring.
-
Disassemble the cartridge.
Main work
Degrease the piston rod.
-
Clamp the piston rod with the special tool as far up as possible.
I
Clamping stand (T14049S)
-
Release hydrostop needle
✓ The valve @ usually remains in the hydrostop needle.
-
• Info e
I
201728-10
C, -
-
Remove the rebound shim stack
-
Remove piston
CD .
out of the reservoir.
@).
4I .
CB.
(a p. 17)
(a p. 19)
(a p. 20)
(a p. 299)
O
and remove it from the piston rod.
silver hydrostop needle on compression damping side.
red hydrostop needle on rebound damping side.
8.
8.
21