Installing The Battery; Recharging The Battery - Husqvarna FE 350 2015 Repair Manual

15
WIRING HARNESS, BATTERY
-
0
_ _
,_ _
---l
e
/1
Recharging the batte
Warning
Battery acid and battery gases cause serious chemical burns.
Risk of injury
Keep batteries out of the reach of children.
-
Wear suitable protective clothing and goggles.
-
Avoid contact with battery acid and battery gases.
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at
least 15 minutes and contact a physician.
Warning
Environmental hazard
Do not dispose of batteries as household waste.
Dispose of batteries at a collection point for used batteries.
Warning
Environmental hazard
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Even when there is no load on the battery, it discharges steadily.
The charging level and the method of charging are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the service life of the battery.
If the charging current, charging voltage, and charging time are exceeded, the battery will be destroyed.
If the battery is depleted from starting the vehicle repeatedly, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sulfated, destroying the
battery.
The battery is maintenance-free, i.e., the acid level does not have to be checked.
\
Main work
Insert the battery into the battery compartment with the terminals facing forward.
I
Battery (YTX5L-BS)
Reconnect rubber band
• Info
I
Contact disks
ets
Position the positive cable and mount and tighten the screw.
Guideline
Screw, battery terminal
o
Slide positive terminal cover
Position the negative cable and mount and tighten the screw.
Guideline
Screw, battery terminal
H00387-10
Slide negative terminal cover
Finishing work
Mount the seat.
Batteries contain environmentally-hazardous materials.
Hazardous substances cause environmental damage.
Preparatory work
Remove the seat.
(� p. 215)
O.
e
must be mounted under screws
0
with the claws toward the battery terminal.
8
over the positive terminal.
fD
over the negative terminal.
(� p. 77)
(Ill:! p. 77)
e
and cable sock­
M5 2.5 Nm
(1.84 lbf ft)
M5 2.5 Nm
(1.84 lbf ft)
109