26 Cleaning/Protective Treatment; Cleaning The Motorcycle - Husqvarna FS 450 2019 Repair Manual

26 CLEANING/PROTECTIVE TREATMENT

26.1
Note
Material damage
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
290
Cleaning the motorc�cle
Components become damaged or destroyed if a pressure cleaner is used incorrectly.
Note
Environmental hazard Hazardous substances cause environmental damage.
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
7//11111111111111\{
401061-01
60 cm (23.6 in)
-
Close off the exhaust system to keep water from entering.
Remove loose dirt first with a soft jet of water.
-
Spray heavily soiled parts with a normal commercial motorcy­
cle cleaner and then brush off with a soft brush.
Motorcycle cleaner (0
Info
I
Use warm water containing normal motorcycle cleaner
and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle;
always rinse the vehicle with water first.
-
After rinsing the motorcycle with a gentle spray of water,
allow it to dry thoroughly.
Remove the closure of the exhaust system.
Warning
Danger of accidents
brake system.
Brake carefully several times to dry out and
remove dirt from the brake linings and the brake
discs.
-
After cleaning, ride the vehicle a short distance until the
engine warms up.
• Info
I
The heat produced causes water at inaccessible loca­
tions in the engine and on the brake system to evapo­
rate.
p. 307)
Moisture and dirt impair the