Checking The Charging Voltage; Checking The Open-Circuit Current - Husqvarna FE 250 2016 Repair Manual

15.7

Checking the charging voltage

15.8 Checking the o en-circuit current
15 WIRING HARNESS, BATTERY
Condition
The battery must be fully functional and completely charged.
-
Preparatory work Remove the seat. (lit!I p. 92)
-
Main work Carry out the start procedure.
Measure the voltage between the specified points.
V
Measuring point
Ground(-)
Charging voltage
I
5,000 rpm
If the displayed value is less than the specified value:
-
Check the plug-in connections from the alternator to
the voltage regulator.
-
Check the plug-in connections from the voltage regu-
lator to the wiring harness.
-
Check the stator winding of the alternator.
If the displayed value is greater than the specified value:
-
Change the voltage regulator.
Preparatory work
-
(FE EU/AU) Press and hold the kill switch (5<;) while the engine is idling
until the engine stops.
-
Remove the seat. (lit!J p. 92)
-
Main work Disconnect the negative cable of the battery.
-
Measure the current between battery ground (-) and the neg-
ative cable.
Info
The value of the open-circuit current only applies to
vehicles in their original state without additional power
consumers.
I
imum open-circuit cur-
� ��
If the measured value is greater than the specified value:
-
Disconnect the voltage regulator from the wiring har­
ness and perform the measurement again.
(lit!I p. 12)
- Measuring point
Plus(+)
1 .5 ... 15.0 V
1 3
(lit!I
I
< 1.0 mA
p. 244)
..
..
131