Removing Cutterbar Spindles - MacDon R113 Operator's Manual

Removing Cutterbar Spindles

DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage header lift cylinder lock-out valves before going under machine for any reason.
CAUTION
Cutter blades have two cutting edges. Exercise caution when working around the blades. Blades are sharp
and can cause serious injury. Wear gloves when handling blades.
1. Lower mower conditioner fully, shut off engine, and
remove key.
NOTE:
Ensure mower conditioner is on a flat, level
surface and is tilted all the way back before
removing spindles to prevent oil from spilling
from the cutterbar.
2. Open cutterbar door(s).
3. Place a pin (or equivalent) in the front hole of the rock
guard (B) to prevent disc rotation while loosening bolts.
4. Remove four M12 bolts (A) and washers.
169820
MAINTENANCE AND SERVICING
146
Figure 4.48: Cutterbar Doors
Figure 4.49: Cutterbar Disc Bolts
Revision A