3. Close the steering lock-out valve by turning the handle
to the vertical position.
4. Raise the mower conditioner fully, and close the
cylinder lock-out valve (A) on each lift cylinder by
turning the handle to the horizontal position.
WARNING
Do NOT tow unless the steering cylinder is fully
charged. If steering cylinder is not fully charged,
loss of control, injury, or death could result.
5. Move jack (A) to storage position on side of hitch, and
secure with pin (B).
6. Ensure tires are properly inflated.
7. Keep Slow Moving Vehicle (SMV) sign, reflectors, and
lights clean and visible at rear of mower conditioner.
3.15.2 Transporting with a Tractor
If towing endwise with the optional endwise transport system, refer to
to prepare the mower conditioner for transport; otherwise, refer to
page 71
Transport, page
65.
169820
OPERATION
Figure 3.60: Steering Lock-Out Valve in
Open Position
Figure 3.61: Cylinder Lock-Out Valve
Figure 3.62: Jack in Storage Position
Converting from Field to Transport Mode,
66
3.15.1 Preparing Mower Conditioner for
Revision A