3.4 Cutterbar Doors
WARNING
Do NOT operate the machine without all the cutterbar
doors down or without curtains installed and in
good condition.
There are two doors (A) that provide access to the
cutterbar area.
Rubber outboard curtains (B) are attached to each front
corner, and an inboard curtain (C) is installed at the center
fixed cover location. Always keep these curtains down
when operating the mower conditioner.
IMPORTANT:
Replace curtains if they become worn or damaged.
Refer to
4.5.6 Curtains, page 160
for replacement instructions.
3.4.1 Opening Cutterbar Doors
1. Lift door at front to move to open position.
NOTE:
Center header beneath hitch to open both doors.
3.4.2 Closing Cutterbar Doors
CAUTION
To avoid injury, keep hands and fingers away from corners of doors when closing.
169820
OPERATION
or contact your Dealer
38
Figure 3.14: Cutterbar Doors and Curtains
Figure 3.15: Open Cutterbar Door
Revision A