Greasing Procedure - MacDon R113 Operator's Manual

Greasing Procedure

CAUTION
Stop engine, and remove key from ignition before leaving operator's seat for any reason. A child or even
a pet could engage an idling machine.
1. Open driveshields at ends of mower conditioner to access greasing points. Refer to
page 33.
2. Use only recommended lubricants specified in this manual. Refer to
3. Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
4. Inject grease through fitting with grease gun until grease overflows fitting, except where noted.
5. Leave excess grease on fitting to keep out dirt.
6. Replace any loose or broken fittings immediately.
7. If fitting will NOT take grease, remove and clean thoroughly. Also clean lubricant passageway. Replace fitting
if necessary.
8. Use clean High Temperature Extreme Pressure grease only.
169820
MAINTENANCE AND SERVICING
126
3.2.1 Opening Driveshields,
4.3.1 Recommended Lubricants, page 106.
Revision A