Removing Driven Rotary Deflectors And Driveline - MacDon R113 Operator's Manual

3. Inspect deflectors (A) and (B) for damage and wear,
and replace if deflectors are worn at the center to
50% or more of their original thickness.
repair deflectors.
4. Examine drums for significantly sized dents. Replace
dented drums to prevent an imbalance in the cutterbar.
5. Check for loose or missing fasteners and tighten or
replace missing fasteners.
WARNING
Ensure cutterbar is completely clear of foreign
objects. Foreign objects can be ejected with
considerable force when the machine is started and
may result in serious injury or machine damage.
6. Close cutterbar doors.
Removing Driven Rotary Deflectors and Driveline
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage header lift cylinder lock-out valves before going under machine for any reason.
CAUTION
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
NOTE:
Images shown are for left side rotary deflector and driveline—right side rotary deflector and driveline is similar.
1. Open cutterbar doors (refer to
Doors, page 159).
169820
MAINTENANCE AND SERVICING
Do NOT
Opening Cutterbar
174
Figure 4.114: Rotary Deflectors
Figure 4.115: Cutterbar Doors
Revision A