Installing Rock Guards - MacDon R113 Operator's Manual

2. Slide rock guard (A) forward in the direction of arrow (B)
and remove.

Installing Rock Guards

1. Guide rock guard onto cutterbar until tabs (A) sit on top
of the cutterbar while bottom back bolt holes line up.
2. Install two hex head screws, washers, and lock nuts
(A). Torque to 50 ft·lbf (68 N·m).
169820
MAINTENANCE AND SERVICING
172
Figure 4.109: Rock Guard Removed
from Cutterbar
Figure 4.110: Rock Guard Installed on Cutterbar
Figure 4.111: Rock Guard Hardware
Revision A