Draining Cutterbar - MacDon R113 Operator's Manual

Draining Cutterbar

1. Park the mower conditioner on level ground.
2. Place a block under each end of the mower conditioner.
NOTE:
Block mower conditioner so one end is higher
than the opposite end.
3. Clean around cutterbar end plate (B).
4. Place a suitably sized container under lower end
of cutterbar.
5. Remove two M10 hex head bolts (A) and washers,
and remove cutterbar end plate (B) from lower end
of cutterbar.
IMPORTANT:
Do NOT flush the cutterbar.
6. Allow sufficient time for lubricant to drain, replace
cutterbar end plate (B) and two M10 hex head bolts (A)
and washers, and tighten.
7. Properly dispose of lubricant.
169820
MAINTENANCE AND SERVICING
138
Figure 4.36: Tilted Mower Conditioner and
Cutterbar End Plate
Revision A