Safety Signs; Installing Safety Decals - MacDon R113 Operator's Manual

1.7 Safety Signs

• Keep safety signs clean and legible at all times.
• Replace safety signs
become illegible.
• If original parts on which a safety sign was installed are
replaced, be sure the repair part also bears the current
safety sign.
• Safety signs are
Parts Department.

1.7.1 Installing Safety Decals

1. Clean and dry the installation area.
2. Decide on the exact location before you remove the decal backing paper.
3. Remove the smaller portion of the split backing paper.
4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is applied.
5. Prick small air pockets with a pin and smooth out.
169820
that are missing
available from your
SAFETY
or
Dealer
Figure 1.16: Operator's Manual Decal
8
Revision A