Detaching The Header (M200 Windrowers) - MacDon R85 Operator's Manual

5.8.2 Detaching the Header (M200 Windrowers)

Refer to your windrower operator's manual for procedure to mechanically detach the header from a windrower. Refer
to the following procedure to disconnect electrical and hydraulic systems:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Lower the header to ground. If ground is soft, place
blocks under header.
2. Stop engine and remove key.
3. Move the left side (cab-forward) platform (A) to the
open position.
4. Disconnect the pressure hose (A) from port (M2) on the
header drive valve block.
5. Disconnect the return hose (B) from port (R2) on the
header drive valve block.
6. Install plugs and caps on open windrower lines and
header hoses.
169455
OPERATION
Figure 5.71: Windrower LH Platform
Figure 5.72: Hydraulic Connections
59
Revision F