Filling The Cutterbar Lubricant - MacDon R85 Operator's Manual

Filling the Cutterbar Lubricant

DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine: stop engine, remove
key, and engage safety props before going under machine for any reason.
CAUTION
Never start or move the machine until you are sure all bystanders have cleared the area.
1. Park the machine on level ground.
2. Raise header fully.
3. Stop the engine and remove the key.
4. Engage header safety props. Refer to
Safety Props, page
5. Move higher block to right end of header.
NOTE:
Having the fill end higher allows for quicker filling
of cutterbar.
6. Disengage header safety props. Refer to
Safety Props, page
7. Start windrower and lower header onto blocks (A).
8. Start windrower and lower header onto blocks (A).
9. Stop the engine and remove the key.
169455
MAINTENANCE AND SERVICING
5.3 Header
24.
5.3 Header
24.
Figure 7.25: Header Raised Left Side
122
Revision F