Opening The Driveshield: Export Headers; Closing The Driveshield: Export Headers - MacDon R85 Operator's Manual

5.4.3 Opening the Driveshield: Export Headers

Follow these steps to open the driveshield on export headers:
1. Release rubber latch (A).
2. Insert a screwdriver (or equivalent) through hole (B)
in driveshield and into the notch in latch (C) and
disengage latch.
3. Open driveshield (D).

5.4.4 Closing the Driveshield: Export Headers

Follow these steps to close the driveshield on export headers:
1. Lower the shield (A) so that at lower end of driveshield
engage holes in the lower panel and latch (B)
reengages shield.
2. Engage rubber latch (C).
169455
OPERATION
Figure 5.7: Driveshield
Figure 5.8: Driveshield
27
Revision F