MacDon R85 Operator's Manual page 92

The swath baffle (A) determines the width and height of
the windrow. It is located immediately behind and above
the conditioning rolls and can be positioned to
• direct the crop flow into the forming shield for narrow and
moderate width windrows
• direct crop downward to form a wide swath
To adjust the swath baffle, follow these steps:
1. Remove lynch pin from pin (B) and remove pin from
lever (C).
2. Move lever to middle hole in bracket and reinstall
pin (B) through lever and bracket.
3. Secure with lynch pin.
NOTE:
Swath baffle position may need to be adjusted for proper
pin engagement. Loosen bolts (A) and adjust bracket (B)
and baffle as required. Tighten bolts (A).
169455
OPERATING THE HEADER
Figure 6.13: Swath Baffle Lever
Figure 6.14: Swath Baffle Lever
82
Revision F