Detaching The Header: M200 Windrowers - MacDon R85 Operator's Manual

3.8.2 Detaching the Header: M200 Windrowers

Refer to your windrower operator's manual for procedure to mechanically detach the header from a windrower. Refer
to the following procedure to disconnect electrical and hydraulic systems:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header to ground. If ground is soft, place
blocks under header.
2. Stop the engine and remove the key.
3. Move the left side (cab-forward) platform (A) to the
open position.
4. Disconnect the pressure hose (A) from port (M2) on the
header drive valve block.
5. Disconnect the return hose (B) from port (R2) on the
header drive valve block.
6. Install plugs and caps on open windrower lines and
header hoses.
147757
OPERATION
Figure 3.73: Windrower LH Platform
Figure 3.74: Hydraulic Connections
62
Revision B