MacDon R85 Operator's Manual page 131

Figure 7.23: Cutterbar Filler Plug Locations
10. Locate one of the two filler plugs along the top of
the cutterbar. Refer to
Locations, page 121.
11. Clean around either filler plug (A) and remove one plug
with an 8 mm hex key.
NOTE:
Rotate disc to expose filler plug if necessary.
12. Place a suitably sized container under the cutterbar
drain hole (A).
13. Remove plug (A) with an 8 mm hex key and allow
sufficient time for lubricant to drain.
IMPORTANT:
Do NOT flush the cutterbar.
14. Replace drain plug (A) and tighten.
15. Safely dispose of lubricant.
16. Add lubricant. Refer to
page 122.
169455
MAINTENANCE AND SERVICING
7.23: Cutterbar Filler Plug
Filling the Cutterbar Lubricant,
Figure 7.24: Cutterbar Lubricant Drain
121
Revision F