9. Reattach upper driveline to driven pulley (B) with
bolts and washers (A). Check roll timing before fully
tightening bolts. Refer to
page
77.
10. Torque bolts to 75 ft·lbf (102 N·m).
11. Reinstall lower driveshield.
12. Close driveshield.
7.7.3 Conditioner Gearbox
The conditioner gearbox (A), which transfers power from
the bevel gearbox to the conditioner rolls , is located inside
the drive compartment at the left end of the header.
The gearbox does not require normal maintenance
or servicing.
If repairs are required, the conditioner gearbox should be
removed and serviced at your MacDon Dealer.
169455
MAINTENANCE AND SERVICING
6.4.1 Checking Roll Timing,
Figure 7.75: Conditioner Drive Belt
Figure 7.76: Conditioner Gearbox
150
Revision F