Installing The Hydraulic Motor - MacDon R85 Operator's Manual

6. Cover gearbox opening (A) with a rag or plastic.

Installing the Hydraulic Motor

Follow these steps to install the hydraulic motor:
1. Remove covering from gearbox opening (A).
2. Attach a sling to the motor with the opposite end to a
lifting device.
NOTE:
Do not lift the motor with hydraulic lines.
3. Lower the motor (B) on gearbox opening.
4. Install four bolts (D). Torque to 103 ft·lbf (140 N·m).
5. Remove caps from motor ports and hoses and
reconnect hoses (A and C) to motor.
NOTE:
Hydraulic connections vary depending on the
windrower. Refer to the specific instruction
supplied with your hydraulic drive kit.
169455
MAINTENANCE AND SERVICING
154
Figure 7.84: Hydraulic Motor Removed
Figure 7.85: Hydraulic Motor Removed
Figure 7.86: Hydraulic Motor (M200 Shown)
Revision F