Replacing Latch Brackets - MacDon R85 Operator's Manual

Replacing Latch Brackets

To replace the cutterbar door latch brackets, follow these steps:
1. Open cutterbar door.
2. Remove bolts (A), washers, and nuts, and remove
latch bracket (B) from door.
3. Locate new latch bracket (B) on door and reinstall
bolts (A), washers and nuts. Use three washers on aft
bolt as spacers between bracket (B) and door.
4. Close door and check alignment with latch. Adjust as
necessary and tighten bolts (A).
169455
MAINTENANCE AND SERVICING
144
Figure 7.63: Latch Bracket
Revision F