Hydraulics; Hydraulic Motor; Removing The Hydraulic Motor - MacDon R85 Operator's Manual

7.8 Hydraulics

Refer to your windrower operator's manual for hydraulic system maintenance procedures.

7.8.1 Hydraulic Motor

The hydraulic motor does not require regular maintenance
or servicing. If repairs are required, it should be serviced
by your Dealer.

Removing the Hydraulic Motor

Follow these steps to remove the hydraulic motor:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. If machine is connected to the windrower, lower header
to ground, turn off engine, and remove key.
2. Disconnect case drain hose (A) from motor (B).
3. Disconnect pressure and return hoses at fittings (C).
IMPORTANT:
To protect the motor from contamination and
prevent spillage of excess fluid, install caps and
plugs on open fittings and hoses.
4. Remove four bolts (D).
5. Use a sling and a lifting device to remove the motor.
169455
MAINTENANCE AND SERVICING
153
Figure 7.82: Hydraulic Motor
Figure 7.83: Hydraulic Motor (M200 Shown)
Revision F