MacDon R85 Operator's Manual page 66

4. Disconnect the electrical harness at connector (A).
NOTE:
Valve block hidden to show the electrical
connector.
5. If couplers and coupler lock are installed on lines,
proceed as follows. Otherwise, proceed to Step
page 57.
6. Disconnect 1/2 in. (12.7 mm) hose (B) from windrower
coupler and remove lynch pin (A).
7. Open up coupler lock (A).
8. Remove lock from couplers (B).
169455
OPERATION
13.,
Figure 5.63: Hydraulic Connections
Figure 5.64: Hydraulic Connections
Figure 5.65: Hydraulic Connections
56
Revision F