MacDon R85 Operator's Manual page 134

13. Add lubricant to cutterbar through filler hole (A). Refer
to
7.4 Recommended Fluids and Lubricants, page
IMPORTANT:
DO NOT overfill the cutterbar. Overfilling can
cause overheating and damage to or failure of
the cutterbar will occur.
14. Install the filler plug that was removed.
15. Close cutterbar door(s). Refer to
page 28.
16. Start engine and raise header off blocks.
17. Engage header safety props.
18. Remove blocks and lower header.
19. Stop engine and remove key from ignition.
20. Disengage header safety props.
21. Start engine and lower the header fully.
169455
MAINTENANCE AND SERVICING
109.
5.5 Cutterbar Doors,
124
Revision F