Detaching The Header: M200 Windrowers - MacDon R85 Operator's Manual

3.8.3 Detaching the Header: M200 Windrowers

Refer to your windrower operator's manual for procedure to mechanically detach the header from a windrower.
Refer to the following procedure to disconnect electrical and hydraulic systems:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header to the ground. If the ground is soft, place blocks under the header.
2. Stop the engine and remove the key.
3. Move left side (cab-forward) platform (A) to the
open position. For instructions, refer to the windrower
operator's manual.
4. Disconnect pressure hose (A) from port (M2) on the
header drive valve block.
5. Disconnect return hose (B) from port (R2) on the
header drive valve block.
6. Install plugs and caps on open windrower lines and
header hoses.
214366
OPERATION
Figure 3.96: Windrower Left Platform
M2
Figure 3.97: Hydraulic Connections
75
A
R2
R 2
1
M
2
M
A
B
Revision A