Installing The Shift Drum Locating Unit; Installing The Shift Shaft; Installing The Starter Idler Gear; Installing The Torque Limiter - Husqvarna FE 450 2016 Repair Manual

18 ENGINE
18.5.12
18.5.13
18.5.14
18.5.15
234

Installing the shift drum locating unit

Installing the shift shaft

Installing the starter idler gear

Installing the torque limiter

-
Push away locking lever
and position the shift drum locating unit @.
Info
The flat areas of the shift drum locating unit are not
symmetric.
-
Relieve tension from the locking lever.
-
Mount and tighten screw (D.
Guideline
Screw, shift M6
drum locating
O
-
Slide shift shaft with the washer into the bearing seat.
8
Push sliding plate away from the shift drum locating unit.
Insert the shift shaft all the way.
8
-
Let sliding plate engage in the shift drum locating unit.
-
Shift through the transmission.
-
Slide on starter idler gear
case.
-
Slide on the disk. Mount the lock ring.
-
Position the washer.
O.
-
Slide on torque limiter
the washer.
Guideline
Screw, torque M6
governor
O
from the shift drum locating unit
10 Nm (7.4 lbf ft)
Loctite
O
with the collar facing the engine
Mount and tighten the screw with
10 Nm (7.4 lbf ft)
Loctite
..
®
243
™
..
..
®
243 ™