Husqvarna FE 450 2016 Repair Manual page 134

14 WHEELS
l
o
132
l
o o-- �--0 o
16 17 18
2 3
400987-10
-
Pull at the top part of the chain with the specified weight fj.
Guideline
Weight of chain wear mea­
surement
-
Measure distance
section.
Info
Chain wear is not always even, so you should repeat
this measurement at different chain positions.
Maximum distance
the longest chain section
0
If distance
-
Change the drivetrain kit.
o
• Info
I
When a new chain is mounted, the rear
sprocket and engine sprocket should also be
changed.
New chains wear out faster on old, worn
sprockets.
-
Check the chain sliding guard for wear.
If the lower edge of the chain pins is in line with or below
the chain sliding guard:
-
Change the chain sliding guard.
-
Check that the chain sliding guard is firmly seated.
If the chain sliding guard is loose:
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain
sliding guard
10 ... 15 kg (22 ... 33 lb.)
0
of 18 chain rollers in the lower chain
0
272 mm (10. 71 in)
at
is greater than the specified measurement:
(� p. 134)
M6 6 Nm (4.4 lbf ft)
Loctite
®
243
™